The PS2 is a complete 4KW, 230VAC 50Hz system comprising:
2	FX Inverters
1	PS2MP
2	FXA-Kit
1	PS2AC-50D
1	PS2DC-175
1	OBDC-175
1	Hub & Mate

The FX Inverters
The OutBack true sinewave inverter/charger is a complete power solution. It incorporates a DC to AC true sinewave inverter, battery charger and AC transfer switch all housed within a die-cast aluminum chassis. “Smart” multistage battery charging means less generator “on” time, and extends the life of your batteries. Outback’s modular system architecture permits flexibility allowing small systems the ability to increase the power output as the demand grows from 2 to 30kW - even in 3-phase configurations. Non-volatile memory retains all programming information even when the inverter isn’t on.

The FX series uses a sealed chassis that can operate in the harshest environmental conditions such as high humidity and corrosive salt air - excellent for coastal and marine installations.

PS2MP
The PS2MP is a steel powder coated, one-part mounting plate for all your PS2 series accessories and up to two OutBack Inverter/Chargers.

FXA-Kit

PS2AC-50D
OutBack Power Systems has developed a single box solution for all of the AC components of a renewable energy system. The PSAC saves time, money and space by combining all of the disconnects, overcurrent protection, grounding and transformer components into an easy to install, single enclosure. The PSAC is easily modified and expanded as your system grows or changes.

PS2DC-175
OutBack Power Systems has developed a new solution for all of the DC components of a renewable energy power conversion system. The PSDC saves time, money and space by combining the disconnects, overcurrent protection devices, grounding and control components into an easy to install, single enclosure. The PSDC is easily modified and expanded as your system grows or changes.

OBDC-175
The OBDC-175 panel mounted Hydralic-Magnetic type breaker is rated at 175 amp 125 VDC with a 3/8” stud terminal and is 39mm in width. It can be used for DC sources, inverters or load circuits.

Hub & Mate
The OutBack MATE is a complete system controller and display for both the OutBack FX2000 inverter/charger and MX60 MPPT PV charge controller. It provides a display of the operation as well as allows control and adjustment of the setpoints. The OutBack Mate also coordinates the operation of the entire system to maximize performance and to prevent multiple products from conflicting.

A single OutBack MATE is able to connect to multiple FX2000 inverter/charges, MX60 MPPT PV charge controllers and any other OutBack power conversion and control products offered in the future. A maximum of ten OutBack products will be able to be connected to a single MATE via CAT 5 / ethernet type cabling with 8 wire RJ45 modular connectors and the OutBack HUB communication manager.

The OutBack MATE includes a 4 line backlit LCD display with 80 alphanumeric characters. This allows multiple measurements to be displayed at the same time and reduces the amount of abbreviations required, simplifying the operation and reducing confusion. All of the programmed setpoints are stored in permanent memory to eliminate the need to reprogram the system after a shutdown or battery replacement.

The OutBack MATE also includes a built in real time clock and calendar which allows programming of the inverter operation based on the time of day and even day of the week. This can be used to allow the system to work with time-of-day power rates or to limit a generator's run time to a specific time period of the day or week.

The OutBack MATE also includes an opto-isolated RS232 port with a DB9 jack for connection to the serial port of a PC computer.